Power Down Server Gracefully Using the On/Standby Button
■
“Use the On/Standby Button for Immediate Shutdown” on page 56
■
“Power On the Server” on page 214
Power Down Server Gracefully Using the On/Standby Button
1.
Press and quickly release the On/Standby button on the front panel.
This action causes ACPI-enabled operating systems to perform an orderly shutdown of the
operating system. Servers not running ACPI-enabled operating systems shut down to Standby
power mode immediately.
When main power is off, the System OK LED on the front panel will begin flashing,
indicating that the server is in Standby power mode. See “Server System-Level Status
Indicators” on page 29.
2.
Disconnect the power cords and data cables from the server.
See “Disconnect Cables From the Server” on page 58.
Caution - When you power down the server using the On/Standby button, the server enters
Standby power mode. Power is still directed to the service processor and power supply fans. To
completely power off the server, you must disconnect the power cords from the power supplies.
Related Information
■
“Server System-Level Status Indicators” on page 29
■
“Power Down Server Gracefully Using the Oracle ILOM CLI” on page 54
■
“Power Down Server Gracefully Using the Oracle ILOM Web Interface” on page 55
■
“Use the On/Standby Button for Immediate Shutdown” on page 56
■
“Power On the Server” on page 214
Use the On/Standby Button for Immediate Shutdown
Caution - An immediate power down might corrupt system data, therefore, only use this
procedure to power down the server after attempting the graceful power down procedure.
1.
Press and hold the On/Standby button for four seconds to force the Main power
off and to enter Standby power mode.
When Main power is off, the System OK LED on the front panel begins flashing, indicating that
the server is in Standby power mode. See “Server System-Level Status Indicators” on page 29.
56 Oracle Server X7-2 Service Manual • October 2017
To Next Page
Loading...
Need help?
General
