CMTimeChart Monitor
14-18
When Trigger mode is "Normal"
After the logging operation is executed, the data at the point of time whenever the trigger
condition is met will be logged and stored as data. When the "Upload logging data" operation
is performed on CMTimeChart, the time chart displays only the latest information.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
(UM 02630_bit0)
(UM 02631_bit0)
(UM 02632_bit0)
(UM 02633_bit0)
(YB)
(XB)
Announce trigger registration
Allow trigger use
Waveform logging active
annunciation
Trigger detection
Logging flag
Presence/absence of
logging data
Waveform logging enable
Measurement
time
Measurement
time
Measurement
time
(Note): If the waveform logging enable (YB) flag turns on before turning on "Allow Trigger Use (UM02631)", the
logging operation will not be executed.
(Note)
To Next Page
Loading...
