16.10 Unit Memories (Cam Pattern Editing Area)
16-87
●: Available, -: Not available
Axis no.
Unit
memory
no. (Hex)
Name Default
Description R W
- UM 66F46
section 1
U0
When reading, the cam curve of the read cam
pattern table is stored.
When rewriting, the cam curve of the rewritten cam
pattern table is set.
bit Name Description
15-0
Cam
curve
setting
11: Constant acceleration
12: Simple harmonic motion
22: Cycloid
25: Modified trapezoid
26: Modified sine
27: Modified uniform velocity
33: Asymmetric cycloid
34: Asymmetric modified
trapezoid
35: Trapecloid
43: One-dwell cycloid m=1
44: One-dwell cycloid m=2/3
45: One-dwell modified
trapezoid m=1
46: One-dwell modified
trapezoid (Ferguson)
47: One-dwell modified
trapezoid m=2/3
48: One-dwell modified sine
49: One-dwell trapecloid
No-dwell modified trapezoid
52: No-dwell modified uniform
velocity
92: NC2 curve
Any other settings will be errors.
- UM 66F47
Reserved for
system
- - - -
To Next Page
Loading...
