Phoenix Contact PSRmodular - Figure 5-97: LOGICAL MACRO Operator; Figure 5-98: Example for LOGICAL MACRO with Just One Input for In- Put Logic 2

PSRmodular system
138 / 232
PHOENIX CONTACT 109241_en_03
5.4.1.8 LOGICAL MACRO
This operator enables two or three logical operators to be grouped. It is intended for a max-
imum of eight inputs. The result of the two operators is included in a third operator, whose
result is represented by the “O
UT” output.
Figure 5-97 “LOGICAL MACRO” operator
Parameters
Input Logic 1 and Input
Logic 2
Enables the entry of the respective number of inputs from 1 ...7.
If either of the two parameters (“Input Logic 1” or “Input Logic 2”) is set to logic “1”, the cor-
responding operator is deactivated, and the input is connected directly to “Operator 3” (see
example in the figure below):
Figure 5-98 Example for “LOGICAL MACRO” with just one input for “Input Logic 2”