Phoenix Contact PSRmodular - Changing the Hardware Configuration

PSRmodular Software: Basics
109241_en_03 PHOENIX CONTACT 41 / 232
Figure 4-3 Configuration overview
4.2.3 Changing the hardware configuration
Select the icon to change the hardware configuration.
– Extension modules can be positioned on both sides of the base module. The order
they are selected in makes no difference.
– For some extension modules (PSR-M-EM, PSR-M-GW), the type must also be se-
lected via a second pull-down menu below the address selection.
Selection of the extension
module that is to be added
Select number of local
bus extensions
Disables reading of the
PSR-M-MEMORY
Address selec-
tion (0 ... 3)
Module type
selection
(PSR-M-EM and
PSR-M-GW)
Firmware version:
PSR-M-B2
≥ 5.0
PSR-M-B1 < 5.0