PSRmodular system
40 / 232
PHOENIX CONTACT 109241_en_03
4.2.2 Creating a new project
Select the icon in the standard tool bar to create a new project. Enter the corresponding
project information in the dialog box.
Figure 4-2 PSRmodular project information
The PSRmodular Software opens the configuration window for the hardware; only the
PSR-M-B2 base module appears in the window.
The PSR-M-B1 module can be selected via the pull-down menu below the base module by
selecting the FW version. For PSR-M-B1 this is FW < 5.0, for PSR-M-B2 it is FW
≥ 5.0.
The user can add the required modules to their system by selecting the extension module
in the pull-down menu at the top.
Each extension module is then assigned an address from the address range
ADR0 ... ADR3. Please note that modules of the same type must each be assigned a unique
address.
To Next Page
Loading...