Phoenix Contact PSRmodular - Figure 5-180 Connector Variable; Figure 5-181 TERMINATOR Operator

PSRmodular system
202 / 232
PHOENIX CONTACT 109241_en_03
5.6.1.5 Connector In/Out
If the circuit diagram is very large and a connection is required between two items/operators
that are some distance apart, the “Connector” variable can be used
.
Figure 5-180 “Connector” variable
The “Connector Out” variable must have the same connection name as the “Connector In”
variable of that connection.
5.6.1.6 TERMINATOR
This operator acts as a terminator and can be linked to an “O
UT” output signal of an input
block that is not used in the circuit diagram. The input connected to the TERMINATOR op-
erator can be transmitted to a higher-level PLC as diagnostic information.
Figure 5-181 “TERMINATOR” operator
Connector InConnector Out