Phoenix Contact PSRmodular - Figure 5-127: COUNTER COMPARATOR Operator

Items and operators of the PSRmodular Software
109241_en_03 PHOENIX CONTACT 165 / 232
Counter value If this parameter is selected, the current count value can be forwarded to “COUNTER COM-
PARATOR” operators.
5.4.4.2 COUNTER COMPARATOR
This operator enables the value at the “C
OUNTER” input to be compared with the entered
threshold value. Output “Q” is logic “0” as long as the value of “C
OUNTER” is below the
threshold value; it changes to logic “1” when the value of “C
OUNTER” is equal to or greater
than the threshold value.
Figure 5-127 “COUNTER COMPARATOR” operator
NOTE:
The “COUNTER COMPARATOR” operator can only be connected to the output of a
“COUNTER” operator. Multiple “COUNTER COMPARATOR” operators can be con-
nected to each “COUNTER” operator.