Phoenix Contact PSRmodular - Figure 5-186 Display of Results in a Simulation Graphic; Figure 5-187 Managing Dynamic Simulation Selection Menu

PSRmodular system
206 / 232
PHOENIX CONTACT 109241_en_03
Dynamic simulation Click the icon to start the Dynamic Simulation.
The Dynamic Simulation enables the graphical representation of the time characteristic of
the signals. The user must first define trigger signals in a text file template, i.e., they must
specify the time characteristic of the signals used (logic “1” or “0”). Based on the text file cre-
ated, the simulator ensures that a dynamic sequence is generated in the circuit diagram and
the signal characteristic is represented in a time diagram.
From the simulation graphic, it is possible to print the displayed signals (using the “Print”
icon), save the results (using the “Save” icon) so that they can be loaded again, and select
additional signals that should be shown (using the “Change visibility” icon). The signal
names correspond to the designations at the function blocks.
The simulation graphic is exited by clicking the close icon (“X” in the top right corner).
Figure 5-186 Display of results in a simulation graphic
When you click the icon, the “Managing dynamic simulation” selection menu appears
as follows:
Figure 5-187 “Managing dynamic simulation” selection menu
– The “Change visibility” button can be used to add signals to the simulation graphic or
remove them.