Phoenix Contact PSRmodular - Figure 5-6: Project Example with SINGLE;DUAL-OUTPUT Function Block; Figure 5-7: Basic Circuit Diagram of the Outputs for the SINGLE;DUAL- OUTPUT Function Block

Items and operators of the PSRmodular Software
109241_en_03 PHOENIX CONTACT 63 / 232
Figure 5-6 Project example with “SINGLE/DUAL-OUTPUT” function block
Below is the basic circuit diagram for the PSR-M-B2, PSR-M-EF1, and PSR-M-EF5 mod-
ules:
Figure 5-7 Basic circuit diagram of the outputs for the SINGLE/DUAL-OUTPUT func-
tion block
Manual Reset When this option is activated, on every signal change (1 --> 0 --> 1) at the “I
N” input the “FB-
K_RST” input must detect a rising edge in order to control the outputs (“O
UT 1” and “OUT 2”)
(logic “1” signal).
If this option is deactivated, the enable of the output directly follows the input conditions at
terminal point “I
N” (“Reset Type”: “Automatic”).
ADR
O1 O2
O4 O3
FBK_RST1
FBK_RST2
FBK_RST3
FBK_RST4