Phoenix Contact PSRmodular - Figure 5-10 MONITORING-OUT Function Block; Figure 5-11 External Output Signal (EQ)

To Next Page

To Previous Page

Items and operators of the PSRmodular Software

109241_en_03 PHOENIX CONTACT 65 / 232

5.1.1.3 MONITORING-OUT function block

The output of the “MONITORING-OUT” function block is a non-safety-related signal output.

This output is only intended to be connected for diagnostic purposes. The function block

can be used to monitor any status in the configuration. To do this, the status information that

is to be output is connected to the input of the “MONITORING-OUT” function block. The out-

put is controlled when the input is set to logic “1” or is reset when the input is set to logic “0”.

Figure 5-10 “MONITORING-OUT” function block

5.1.1.4 External output signal (EQ)

Here, you can select a maximum of 32 external output signals with PSR-M-B2 and PSR-M-

GW as of Firmware Version 2.0.

At fieldbus level, the states are represented with 4 bytes for PSR-M-B2 and 2 bytes for

PSR-M-B1 (maximum of 16 external output signals).

Figure 5-11 External output signal (EQ)

NOTE:

The “O

UT” output is not a safety output.

NOTE:

An external output signal is not a safety output.