Phoenix Contact PSRmodular - Figure 5-108: MACRO MONITORED RESET Operator

PSRmodular system
148 / 232
PHOENIX CONTACT 109241_en_03
Enable Out If this option is selected, an output containing the result of the calculation performed by the
input logic is enabled.
Restart Request If this parameter is selected, a “R
EQUEST” output is made available to demand a restart.
5.4.2.7 MACRO MONITORED RESET
1
The “MACRO MONITORED RESET” operator enables the “Restart” to be triggered with pa-
rameterizable logic functions in accordance with the following truth table.
Figure 5-108 “MACRO MONITORED RESET” operator
Input Logic Enables the selection of the number of inputs for the Input logic (from 1 to 7). If 1 is selected,
the logic is not taken into consideration.
Select Logic Enables the selection of the operator type. Selection options: AND, NAND, OR, NOR, XOR,
XNOR.
Reset Input Logic
(PSR-M-B2)
Enables the selection of the number of inputs for the Reset logic (from 1 to 7). If 1 is selected,
the logic is not taken into consideration.
1
Maximum number: 16 with PSR-M-B1, 32 with PSR-M-B2,
respectively including other reset operators
CLEAR
Out Input
logic
Out Restart
logic
OUT
Restart
Request
1 0/1 0/1 0 0
0/1 0 0/1 0 0
0 1 0 Initial value 0 1
0 1 Falling edge 1 0