Phoenix Contact PSRmodular - Figure 5-18 Correct (Left); Incorrect (Middle and Right) Feedback Signal

PSRmodular system
70 / 232
PHOENIX CONTACT 109241_en_03
Enable Error Out When this parameter is selected, an output (“ERROR”) is made available which signals that
an error has been detected by the function block.
Figure 5-18 Correct (left) / incorrect (middle and right) feedback signal
The “E
RROR” signal is reset in the following cases:
– System switch off and switch on
– Activation of the RESET function (PSR-M-B1, PSR-M-B2)
FBK
E
RROR
OUTPUT
t_fbk
FBK
E
RROR
OUTPUT
FBK
E
RROR
OUTPUT
t_fbk
t_fbk