Items and operators of the PSRmodular Software
109241_en_03 PHOENIX CONTACT 207 / 232
Load Simulation
Enables an existing text file template to be loaded and then starts the simulation. A graph
containing the resulting signals is shown at the end of the simulation.
Create Template
Enables the template text file to be saved with the desired name and at the relevant storage
location. This file contains the names of the signals that correspond to the circuit diagram.
Using a text editor, the user can enter the status of the input signals at certain points in time
together with the duration of the simulation and the step length to be used.
Figure 5-188 Template text file before (left) and after (right) editing
Timing diagram
Enables a previously completed simulation to be loaded in the simulation graphic. In order
to do this, at least one simulation needs to have been saved.
Duration and step
length of the simulation
Signal value Input1 at time t
0
Signal value Input1 at time t
1
Signal value Input1 at time t
2
To Next Page
Loading...