PSRmodular system
56 / 232
PHOENIX CONTACT 109241_en_03
4.2.17 Monitor graphic
For the graphical representation of the I/O states in real time, enable the “Monitor graphic”
function. An online view of the circuit diagram appears containing the current status in-
formation.
The colors used in the graphical real-time display have the following meaning:
When you mouse over a connecting line, you can view diagnostic messages in the tool tip.
Special cases in the moni-
tor graphic
In contrast to the display described above, the lines for the “NETWORK”, “NETWORK_IN”,
and “SERIAL OUTPUT” blocks are displayed as follows:
The safety logic cannot be changed while the monitor function is active. However, the pa-
rameters of an input, item or output can be shown by right-clicking on them and selecting
“Show/hide property”.
Figure 4-19 Graphic monitor display
Gray: Not active
Green: Active
Dashed orange: External error, e.g., plausibility violation in the case of a two-chan-
nel equivalent evaluation
Dashed gray: Pending activation, e.g., reset
“NETWORK” block, “NETWORK_IN” and “NETWORK_OUT” signals: solid thick gray line =
STOP, solid thick green line = RUNNING, solid thick orange line = START
“SERIAL OUTPUT” block: solid thick black line = data transmission
To Next Page
Loading...