R&S FSV3000 Series - Page 767

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
767User Manual 1178.8520.02 ─ 01
● General MSR ACLR Measurement Settings.........................................................767
● MSR Sub Block and Tx Channel Setup................................................................ 767
● MSR Adjacent Channel Setup.............................................................................. 770
● MSR Gap Channel Setup......................................................................................774
● MSR Channel Names........................................................................................... 780
General MSR ACLR Measurement Settings
Useful commands for configuring general MSR ACLR settings described elsewhere:
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:PRESet on page 752
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult? on page 749
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:RESult:PHZ
on page 783
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE on page 748
●
CALCulate<n>:LIMit<li>:ACPower[:STATe] on page 765
●
[SENSe:]POWer:ACHannel:REFerence:TXCHannel:AUTO on page 759
●
[SENSe:]POWer:NCORrection on page 900
●
[SENSe:]POWer:TRACe on page 751
●
[SENSe:]POWer:ACHannel:MODE on page 784
●
[SENSe:]POWer:ACHannel:PRESet on page 751
●
[SENSe:]POWer:ACHannel:SSETup on page 772
MSR Sub Block and Tx Channel Setup
The functions for manual operation are described in Chapter 7.3.5.2, "MSR Sub Block
and Tx Channel Definition", on page 172.
Useful commands for configuring Tx channels described elsewhere:
●
[SENSe:]POWer:ACHannel:SBLock<sb>:NAME[:CHANnel<ch>]
on page 780
Remote commands exclusive to configuring sub blocks and Tx channels
[SENSe:]POWer:ACHannel:FILTer:ALPHa:SBLock<sb>:CHANnel<ch>...............................767
[SENSe:]POWer:ACHannel:FILTer[:STATe]:SBLock<sb>:CHANnel<ch>..............................768
[SENSe:]POWer:ACHannel:SBCount...............................................................................768
[SENSe:]POWer:ACHannel:SBLock<sb>:BWIDth[:CHANnel<ch>]......................................768
[SENSe:]POWer:ACHannel:SBLock<sb>:BANDwidth[:CHANnel<ch>].................................768
[SENSe:]POWer:ACHannel:SBLock<sb>:CENTer[:CHANnel<ch>]......................................769
[SENSe:]POWer:ACHannel:SBLock<sb>:FREQuency:CENTer...........................................769
[SENSe:]POWer:ACHannel:FILTer:ALPHa:SBLock<sb>:CHANnel<ch> <Alpha>
This command defines the roll-off factor for the specified transmission channel's
weighting filter.
Configuring and Performing Measurements