R&S ZNL Series - Page 1021

Command reference
R&S
®
ZNL/ZNLE
1021User Manual 1178.5966.02 ─ 20
Setting parameters:
<MemTraceName> Name of the memory trace (see also Table 11-20).
Range: <memory_trace> is either a string variable
(enclosed in single or double quotes) or one of the
following reserved names (no string vari-
ables):MDATA1 | MDATA2 | MDATA3 | MDATA4 |
MDATA5 | MDATA6 | MDATA7 | MDATA8 (only for
memory traces Mem<n>[Trc<m>], where n = 1, ...
8).
<DataTraceName> Name of the data trace (see also Table 11-20).
Range: <data_trace> is either a string variable (enclosed in
single or double quotes) or one of the following
reserved names (no string variables):CH1DATA |
CH2DATA | CH3DATA | CH4DATA (only for the
active data trace in channels Ch1, Ch2, Ch3, Ch4).
Example:
*RST; :SWE:POIN 20
Create a trace with 20 sweep points, making the created trace
the active trace of channel 1 (omitted optional mnemonic
SENSe1).
CALC:MATH:SDEF 'Trc1 / 2'; :CALC:MATH:STAT ON
Define a mathematical trace, dividing the data trace by 2. Acti-
vate the mathematical mode and display the mathematical trace
instead of the data trace.
TRAC:COPY:MATH 'Mem_Pt20',CH1DATA; :CALC:MATH:
STAT OFF
Copy the current state of the mathematical trace to a memory
trace named "Mem_Pt20". The memory trace is not displayed.
Switch the display back to the data trace.
DISP:WIND:TRAC2:FEED 'MEM_PT20'
Display the created memory trace together with the data trace.
Usage:
Setting only
Manual operation: See "Data & Func to <Destination>" on page 352
11.5.2.19 TRIGger commands
TRIGger[:SEQuence]...
The TRIGger[:SEQence]... commands synchronize the analyzer's measurement
sequences to external events. These events are indicated to the VNA by sending trig-
ger signals via Trigger In or the Aux. Port (R&S ZNL with option R&S FPL1-B5 only).
TRIGger<Ch>[:SEQuence]:HOLDoff..............................................................................1022
TRIGger<Ch>[:SEQuence]:LINK................................................................................... 1022
TRIGger<Ch>[:SEQuence]:MULTiple:HOLDoff................................................................1023
TRIGger<Ch>[:SEQuence]:MULTiple:SLOPe<Num>....................................................... 1023
VNA command reference