R&S ZNL Series - Cal Softtool; Start Cal Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
472User Manual 1178.5966.02 ─ 20
10.12 Cal softtool
The "Cal" softtool provides all functions related to system error calibration and scalar
power calibration. The latter is available for R&S ZNL only.
Access: [Cal]
10.12.1 Start Cal tab
The "Start Cal" tab provides access to all functions for automatic or manual calibration.
Calibration of the R&S ZNL/ZNLE is a fully guided process.
Background information
Refer to the following sections:
●
Chapter 9.5, "Calibration", on page 247
●
Chapter 9.5.5, "Automatic calibration", on page 262
●
Chapter 9.5.6, "Scalar power calibration", on page 272
●
Chapter 9.1.5, "Data flow", on page 190
10.12.1.1 Controls on the Start Cal tab
left
= R&S ZNL
right = R&S ZNLE
●
The "Start Auto Cal" and "Start... (Cal Unit)" buttons are only active if a calibration
unit is connected to the analyzer.
●
If there is more than one channel in the current channel setup at the time you ini-
tiate a calibration, the Channel Selection for Calibration dialog is opened.
Cal softtool