R&S ZNL Series User Manual

Command reference
R&S
®
ZNL/ZNLE
568User Manual 1178.5966.02 ─ 20
SYSTem:SHUTdown
This command shuts down the instrument.
11.3.2 Selecting the operating mode and application
The following commands are required to select the operating mode or the application
and to configure a Sequencer in a remote environment.
● Selecting the mode and applications.................................................................... 568
● Performing a sequence of measurements............................................................ 571
● Programming example: performing a sequence of measurements...................... 573
11.3.2.1 Selecting the mode and applications
DISPlay:ATAB................................................................................................................568
INSTrument:CREate:DUPLicate...................................................................................... 568
INSTrument:CREate[:NEW]............................................................................................ 569
INSTrument:CREate:REPLace........................................................................................ 569
INSTrument:DELete....................................................................................................... 569
INSTrument:LIST?......................................................................................................... 570
INSTrument:REName.....................................................................................................570
INSTrument[:SELect]......................................................................................................571
DISPlay:ATAB <State>
This command switches between the MultiView tab and the most recently displayed
channel setup. If only one channel setup is active, this command has no effect.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
INSTrument:CREate:DUPLicate
This command duplicates the currently selected channel setup, i.e creates a new chan-
nel setup of the same type and with the identical measurement settings. The name of
the new channel setup is the same as the copied channel setup, extended by a con-
secutive number (e.g. "IQAnalyzer" -> "IQAnalyzer 2").
The channel setup to be duplicated must be selected first using the INST:SEL com-
mand.
Usage:
Event
Manual operation: See " Duplicate Current Channel Setup " on page 89
Common instrument commands

R&S ZNL Series Specifications

General

Brand	R&S
Model	ZNL Series
Category	Measuring Instruments
Language	English