R&S ZNL Series - Channel Softtool; Channels Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
525User Manual 1178.5966.02 ─ 20
Ch<n> Calibration Properties/Cal Group <n> Properties
Displays the basic channel settings and the properties of the system error correction
for the channel (calibration group) selected in the "Channel State" ("Pool") table.
In addition, it is stated whether sweep data are available for the selected calibration.
Remote command:
[SENSe<Ch>:]CORRection:DATE?
[SENSe<Ch>:]CORRection:DATA:PARameter<Sfk>?
[SENSe<Chn>:]CORRection:SSTate?
10.13 Channel softtool
The Channel functions select, create and delete channels and optimize the measure-
ment process.
Access: [Channel] hardkey
10.13.1 Channels tab
Allows you to create and delete channels, to modify the channel state, and to select a
channel as the active channel.
You can monitor the channel activity using the OUTPut<Ch>:UPORt[:VALue] com-
mand and the output signals at pins 8 to 11 of the Aux. Port connector.
The Aux. Port is optional for the R&S ZNL (requires R&S FPL1-B5). It is not available
for the R&S ZNLE.
Background information
Refer to Chapter 9.1.3.3, "Active and inactive traces and channels", on page 187.
10.13.1.1 Controls on the Channels tab
Channel softtool