R&S ZNL Series - Y←Sij Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
409User Manual 1178.5966.02 ─ 20
Model
In case a transmission parameter is selected, you can choose between a series
(default), a parallel, and a shunt impedance calculation.
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "Z-S12" |
"Z-S12SER" | "Z-S12PAR" | ...
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "Z-S12" |
"Z-S12SER" | "Z-S12PAR" | ...
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", 'SHUNT-S12' |
'SHUNT-S21'
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", 'SHUNT-S12' |
'SHUNT-S21'
Balanced Ports...
Opens a dialog to configure the logical ports of the analyzer.
See Chapter 10.7.1.3, "Balanced Ports dialog", on page 398.
10.7.5 Y←Sij tab
Selects converted admittances as measured quantities. The admittances are calcula-
ted from the measured S-parameters.
Background information
Refer to the following sections:
●
Chapter 9.3.4, "Admittance parameters", on page 222
●
Chapter 9.3.4.1, "Converted admittances", on page 222
Meas softtool