R&S ZNL Series - Use Cal Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
520User Manual 1178.5966.02 ─ 20
10.12.3.5 External Power Meter Config dialog
Allows to modify configuration of certain external power meters, i.e. settings that are
persistently stored on the power meter (and NOT on the R&S ZNL/ZNLE). This
requires the respective device to be online, i.e. connected, switched on and ready to
be used.
Access:
●
[Cal] > "Pwr Cal Settings" > "Power Meter Config..."
●
[Meas] > "Power Sensor" > "Power Meter Config..."
Deembed Two-Port (All Channels)
Reads and modifies the state of the built-in S-parameter correction that is available on
certain R&S®NRP-Z power sensors. See Application Note 1GP70 "Using S-Parame-
ters with R&S®NRP-Z Power Sensors" for background information. This Application
Note is available on the Rohde & Schwarz internet at http://www.rohde-schwarz.com/
appnotes/1GP70.
Remote command:
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:SPCorrection[:STATe]
10.12.4 Use Cal tab
Provides access to functions for activating, deactivating and managing calibrations.
Background information
Refer to the following sections:
●
Chapter 9.5, "Calibration", on page 247
Cal softtool