R&S ZNL Series - Configuring the Network and Remote Control

Command reference
R&S
®
ZNL/ZNLE
613User Manual 1178.5966.02 ─ 20
SYSTem:DISPlay:LANGuage <Language>
Defines the language of the software-defined interface elements (such as softkeys,
dialog boxes, diagram texts etc.).
Parameters:
<Language> 'EN' | 'ZH_CH' | 'ZH_TW' | 'JA' | 'KO' | 'RU'
'ZH_CH'
Simplified Chinese
'ZH_TW'
Traditional Chinese
*RST: 'EN'
Example:
SYST:DISP:LANG 'JA'
Switches the language of the instrument to Japanese.
11.3.4.5
Configuring the network and remote control
The following commands are required to configure a network or remote control for the
R&S ZNL/ZNLE.
Remote commands exclusive to configuring a network and remote control
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess............................................................... 613
SYSTem:COMMunicate:GPIB[:SELF]:RTERminator.......................................................... 614
SYSTem:COMMunicate:INTernal:REMote........................................................................ 614
SYSTem:DISPlay:LOCK................................................................................................. 615
SYSTem:DISPlay:UPDate...............................................................................................615
SYSTem:ERRor:DISPlay................................................................................................ 615
SYSTem:IDENtify:FACTory..............................................................................................615
SYSTem:IDENtify[:STRing]............................................................................................. 616
SYSTem:KLOCk............................................................................................................ 616
SYSTem:LANGuage.......................................................................................................616
SYSTem:LXI:INFO......................................................................................................... 616
SYSTem:LXI:LANReset.................................................................................................. 617
SYSTem:LXI:MDEScription............................................................................................. 617
SYSTem:LXI:PASSword..................................................................................................617
SYSTem:REVision:FACTory............................................................................................ 617
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <Address>
This command sets the GPIB address of the R&S ZNL/ZNLE.
Parameters:
<Address> Range: 0 to 30
*RST: (no influence on this parameter, factory default 20)
Example:
SYST:COMM:GPIB:ADDR 18
Manual operation: See "GPIB Address" on page 157
Common instrument commands