R&S ZNL Series - Calculate<Chn>:Marker<Mk>:Delta[:State]; Calculate<Chn>:Marker<Mk>:Excursion; Calculate<Chn>:Marker<Mk>:Reference:excursion

Command reference
R&S
®
ZNL/ZNLE
687User Manual 1178.5966.02 ─ 20
SCPI GUI
MIMPedance "Imp Mag" for reflection measurement traces
"Imp Mag series" for transmission measurement
traces
MPIMpedance "Imp Mag" for reflection measurement traces
"Imp Mag parallel" for transmission measurement
traces
MADMittance "Adm Mag" for reflection measurement traces
"Adm Mag series" for transmission measurement
traces
MPADmittance "Adm Mag" for reflection measurement traces
"Adm Mag parallel" for transmission measurement
traces
INDex Index
CALCulate<Chn>:MARKer<Mk>:DELTa[:STATe] <Boolean>
Switches the delta mode for marker <Mk> on trace no. <Chn> on or off. The marker
must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe] ON. If the
active trace contains no reference marker, the command also creates a reference
marker.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number.
Parameters:
<Boolean> ON | OFF - Enables or disables the delta mode.
*RST: OFF
Example: Suppose that the active channel setup contains an active trace
no. 1.
CALC:MARK ON
Create marker no. 1 and set it to the center of the sweep range.
CALC:MARK:DELT ON
Create a reference marker at the center of the sweep range and
set marker 1 to delta mode.
Manual operation: See "Delta Mode" on page 451
CALCulate<Chn>:MARKer<Mk>:EXCursion <Value>
CALCulate<Chn>:MARKer<Mk>:REFerence:EXCursion <TargetSearchVal>
Defines a marker-specific minimum excursion value for peak searches.
Use CALCulate<Chn>:MARKer<Mk>:EXCursion:STATe or CALCulate<Chn>:
MARKer<Mk>:REFerence:EXCursion:STATeto activate it.
VNA command reference