R&S ZNL Series - Calculate<Chn>:Marker<Mk>:Function:result; Calculate<Chn>:Marker<Mk>:Function:span; Calculate<Chn>:Marker<Mk>:Function:start; Calculate<Chn>:Marker<Mk>:Function:stop

Command reference
R&S
®
ZNL/ZNLE
693User Manual 1178.5966.02 ─ 20
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:RESult?
Returns the result (stimulus and response value) of a search started by means of
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute or CALCulate<Chn>:
MARKer<Mk>:REFerence:FUNCtion:EXECute. The search must be executed
before the command is enabled.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number (ignored)
Example: See CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute
Usage: Query only
Manual operation: See "Max / Min" on page 459
CALCulate<Chn>:MARKer<Mk>:FUNCtion:SPAN
Sets the span of the sweep range equal to the absolute value of the first coordinate of
the active delta marker <Mk> on trace no. <Chn>.
Suffix:
<Chn>
.
Channel number used to identify the active trace
<Mk> Marker number.
Example:
*RST; :CALC:MARK ON; MARK:DELTa ON
Create marker 1 in the center of the current sweep range and
enable the delta mode.
CALC:MARK:X 300MHz
Increase the stimulus value of the delta marker by 300 MHz.
CALC:MARK:FUNC:SPAN
Set the sweep range equal to 300 MHz. The sweep range starts
at the reference marker position, i.e. in the center of the analyz-
er's frequency range.
Usage: Event
Manual operation: See "Center = Marker / Start = Marker / Stop = Marker / Span =
Marker" on page 455
CALCulate<Chn>:MARKer<Mk>:FUNCtion:STARt
CALCulate<Chn>:MARKer<Mk>:FUNCtion:STOP
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:STARt
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:STOP
These commands set the STARt or STOP of the sweep range to the stimulus value of
the related marker (see "Marker addressing" on page 681).
Suffix:
<Chn>
.
Channel number used to identify the active trace
VNA command reference