R&S ZNL Series - Calculate<Chn>:Data:nsweep:count; Calculate<Chn>:Data:nsweep:first

Command reference
R&S
®
ZNL/ZNLE
655User Manual 1178.5966.02 ─ 20
CALCulate<Chn>:DATA:NSWeep:COUNt?
Reads the number of completed sweeps in single sweep mode (INITiate<Ch>:
CONTinuous OFF). The trace can be any of the traces acquired during the single
sweep cycle.
Tip:
This command can only be used for [SENSe<Ch>:]SWEep:COUNt > 1.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Example: See CALCulate<Chn>:DATA:NSWeep:FIRSt?
Usage: Query only
CALCulate<Chn>:DATA:NSWeep:FIRSt?
<Format>, <FwCount>[, <FwCountEnd>]
Reads the response values of a trace or a consecutive group of traces acquired in sin-
gle sweep mode (INITiate<Ch>:CONTinuous OFF).
Tip:
This command can only be used for [SENSe<Ch>:]SWEep:COUNt > 1.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Query parameters:
<Format> SDATa
Read unformatted sweep data (fixed parameter): Returns the
real and imaginary part of each measurement point (2 values
per trace point irrespective of the selected trace format).
<FwCount> Number of first sweep to be read. 1 denotes the first sweep
acquired, 2 denotes the second and so forth. The sweep count
in single sweep mode is defined via [SENSe<Ch>:]SWEep:
COUNt.
Range: 1 to sweep count
<FwCountEnd> Number of last sweep to be read. If this parameter is omitted, it
is implicitly set to <FwCount> (a single sweep is read).
Range: <FwCount> to sweep count
Return values:
<Data> Response values either in ASCII or block data format, depend-
ing on the current FORMat[:DATA] setting.
VNA command reference