To Next Page

To Previous Page

Command reference

R&S

ZNL/ZNLE

966User Manual 1178.5966.02 ─ 20

[SENSe<Ch>:]SWEep:TIME........................................................................................... 969

[SENSe<Ch>:]SWEep:TIME:AUTO..................................................................................970

[SENSe<Ch>:]SWEep:TYPE...........................................................................................971

[SENSe<Ch>:]SWEep:COUNt <Sweep>

Defines the channel-specific number of sweeps to be measured and buffered in single

sweep mode (INITiate<Ch>:CONTinuous OFF). Use [SENSe:]SWEep:COUNt:

ALL to define the sweep count for all channels.

Suffix:

<Ch>

Channel number

Parameters:

<Sweep> Number of consecutive sweeps to be measured and buffered.

Range: 1 to 100000

*RST: 1

Example: See CALCulate<Chn>:DATA:NSWeep:FIRSt?

Manual operation: See "Sweeps" on page 344

[SENSe:]SWEep:COUNt:ALL <Sweep>

Defines the number of sweeps to be measured in single sweep mode

(INITiate<Ch>:CONTinuous OFF). The setting is applied to all channels. Use

[SENSe<Ch>:]SWEep:COUNt to define the sweep count for a single channel.

Setting parameters:

<Sweep> Number of consecutive sweeps to be measured.

Range: 1 to 100000

*RST: 1

Example: See Chapter 11.6.2.4, "Data handling", on page 1071.

Usage: Setting only

Manual operation: See "Sweeps" on page 344

[SENSe<Ch>:]SWEep:DWELl <MeasDelay>

Defines the "Meas. Delay" before each partial measurement or the first partial mea-

surement (see [SENSe<Ch>:]SWEep:DWELl:IPOint). Setting a delay disables the

automatic calculation of the (minimum) sweep time (see [SENSe<Ch>:]SWEep:

TIME:AUTO).

Suffix:

<Ch>

Channel number

VNA command reference

R&S ZNL Series User Manual

Other manuals for R&S ZNL Series