R&S ZNL Series - System Configuration Settings; Hardware Information; Information on Versions and Options

General instrument setup
R&S
®
ZNL/ZNLE
128User Manual 1178.5966.02 ─ 20
Remote command:
SYSTem:DISPlay:LANGuage on page 613
7.4 System configuration settings
Access: [Setup] > "System Configuration"
● Hardware information............................................................................................128
● Information on versions and options..................................................................... 128
● System messages.................................................................................................130
● Firmware updates................................................................................................. 131
● General configuration settings.............................................................................. 133
● Additional interfaces..............................................................................................133
7.4.1 Hardware information
Access: [Setup] > "System Configuration" > "Hardware Info"
An overview of the installed hardware in your R&S ZNL/ZNLE is provided.
Every listed component is described by its serial number, part number, model informa-
tion, hardware code, and hardware revision.
This information can be useful when problems occur with the instrument and you
require support from Rohde & Schwarz.
Remote command:
DIAGnostic:SERVice:HWINfo? on page 618
DIAGnostic:SERVice:BATTery:LEVel? on page 618
7.4.2 Information on versions and options
Access: [Setup] > "System Configuration" > "Versions + Options"
System configuration settings