VNA GUI reference
R&S
®
ZNL/ZNLE
309User Manual 1178.5966.02 ─ 20
10 VNA GUI reference
This chapter describes the Graphical User Interface (GUI) of the VNA mode of the
R&S ZNL/ZNLE. For the R&S ZNLE, only this mode is available.
The most convenient way to access the GUI functions is via Softtools. Hence the GUI
reference is structured accordingly.
The softtools, in turn, can be opened via the keys on the (virtual) front panel of the
instrument. For details, see Chapter 10.1, "Function Keys and softtools", on page 309.
In case a GUI function can also be performed via remote control, one or more links at
the end of the function description point to the related remote control commands.
For a general overview of the analyzer's capabilities and their use, refer to Chapter 9,
"VNA concepts and features", on page 184.
10.1 Function Keys and softtools
Most of the Function keys serve as "openers" for an associated softtool in the analyzer
GUI.
By default, the following "opener logic" is applied:
●
If the associated softtool is not displayed, pressing the hardkey
– opens the associated softtool
– activates its first enabled tab (default) or the last used tab (see "Use Default
Tab for Hardkey" on page 142)
– activates the first enabled input control on this tab (if any)
●
If the associated softtool is already displayed, pressing the hardkey
– activates the next enabled tab on the associated softtool (cyclically)
– activates the first enabled input control on this tab (if any)
Function Keys and softtools
To Next Page
Loading...
