VNA GUI reference
R&S
®
ZNL/ZNLE
312User Manual 1178.5966.02 ─ 20
For a Log Freq only "Start Frequency" and "Stop Frequency" can be set.
Note: For segmented frequency sweeps the start and stop frequencies and the num-
ber of sweep points are defined per segment. See Chapter 10.5.2.2, "Define Segments
dialog", on page 333.
Remote command:
[SENSe<Ch>:]FREQuency:STARt
[SENSe<Ch>:]FREQuency:STOP
[SENSe<Ch>:]FREQuency:CENTer
[SENSe<Ch>:]FREQuency:SPAN
SYSTem:FREQuency? (query frequency range of the network analyzer)
Number of Points
Sets the total number of measurement points for CW Mode sweeps.
This value can also be set on the "Sweep Params" tab of the "Sweep"softtool (see
"Number of Points" on page 325).
Remote command:
[SENSe<Ch>:]SWEep:POINts
Stop Time
Defines the sweep range for Time sweeps.
Remote command:
[SENSe<Ch>:]SWEep:TIME
CW Frequency
Sets the fixed frequency for Power, CW Mode, and Time sweeps.
Remote command:
[SENSe<Ch>:]FREQuency:FIXed
[SENSe<Ch>:]FREQuency[:CW]
SOURce<Ch>:FREQuency<PhyPt>:FIXed
SOURce<Ch>:FREQuency<PhyPt>[:CW]
10.2.2 Power tab
The "Power" tab provides settings related to transmit and receive power. It is also dis-
played on the "Bw Avg Power" softtool.
Stimulus softtool
To Next Page
Loading...
