R&S ZNL Series - Page 333

VNA GUI reference
R&S
®
ZNL/ZNLE
333User Manual 1178.5966.02 ─ 20
Tip: Overlapping limit line and ripple limit line segments are not displayed when a
point-based x-axis is active; see Chapter 9.4.1.1, "Rules for limit line definition",
on page 230.
Remote command:
[SENSe<Ch>:]FREQuency:SEGMent:AXIS
10.5.2.2 Define Segments dialog
The "Define Segments" dialog defines all channel settings for a Segmented frequency
sweep and imports or exports segmented sweep settings.
Access: [Sweep] > "Sweep Type" > "Define Segments..."
The dialog contains a table to edit the individual segments of the sweep range. Use the
Displayed Columns dialog to select the columns to be displayed and edited.
Sweep Softtool