What's new in firmware version 1.71
R&S
®
ZNL/ZNLE
21User Manual 1178.5966.02 ─ 20
3 What's new in firmware version 1.71
This section lists the changes introduced in the current version of the R&S ZNL/ZNLE
firmware.
Software version
► To check your R&S ZNL/ZNLE "Instrument Firmware" and "VNA Server" version,
select [SETUP] > "System Config" > "Versions + Options".
Compatibility with Windows 10 version 21H2
On instruments running Windows 10 version 21H2, firmware versions < 1.71 are not
supported.
3.1 Firmware version 1.71
This section lists the changes introduced in firmware version 1.71.
New functionality
●
Power sweep, power meter and power cal support for R&S ZNL
●
Support of Windows 10, version 21H2
New remote control functionality
●
New command MMEMory:STORe:TRACe:OPTion:COMMent to define a comment
to be added to exported trace files
Improvements
●
For calibration kit standards defined using snp files, it is now possible to export
these files
See "Write .s1p File/Write .s2p File" on page 502
●
Command DISPlay[:WINDow<Wnd>]:TRACe:EFEed can now move live and
memory traces between diagram areas
●
Improved power meter LAN detection with updated R&S VISA library
Solved issues
●
With multiple traces and coupled markers in channel <Chn>, adding a marker
<no> greater than 10 using CALCulate<Chn>:MARKer<no>:STATe ON did not
work as expected.
●
If measurement data is available for a calibration, and the related setup was saved
under a different name, then "Repeat Calibration" failed in the resulting recall set
●
If measurement data is available for a calibration of channel no. x and this calibra-
tion was stored to the cal pool, then "Repeat Calibration" failed if the related cal
pool calibration was applied to a channel no. y≠x
●
Changing the smoothing aperture did not take effect immediately
●
"Delay" memory traces used the current stimulus axis instead of the stored one
Firmware version 1.71
To Next Page
Loading...
