To Next Page

To Previous Page

Getting Started

R&S

ZNL/ZNLE

31User Manual 1178.5966.02 ─ 20

Connect the R&S ZNL/ZNLE to the LAN via the LAN interface on the rear panel of

the instrument.

Windows automatically detects the network connection and activates the required

drivers.

By default, the R&S ZNL/ZNLE is configured to use DHCP and no static IP address

is configured.

The default instrument name is <Type><variant>-<serial_number>, for example,

ZNL3-123456. For information on determining the serial number, see Chapter 4.2.2.14,

"Device ID", on page 51.

For more information on LAN configuration, see Chapter 8.5, "How to set up a network

and remote control", on page 164.

4.1.8 Connecting a keyboard

The keyboard is detected automatically when it is connected. The default input lan-

guage is English – US.

However, you can also connect foreign language keyboards; currently the following

languages are supported for the R&S ZNL/ZNLE:

●

German

●

Swiss

●

French

●

Russian

To configure the keyboard language

1. To access the Windows operating system, press the Windows key on the external

keyboard.

2. Select "Start > Settings > Time & language > Region & language > Add a lan-

guage" .

4.1.9 Connecting an external monitor

You can connect an external monitor (or projector) to the "DVI" connector on the rear

panel of the R&S ZNL/ZNLE (see also Chapter 4.2.2.13, "DVI", on page 50).

Preparing for use

R&S ZNL Series User Manual

Other manuals for R&S ZNL Series