General instrument setup
R&S
®
ZNL/ZNLE
119User Manual 1178.5966.02 ─ 20
OCXO Option
The OCXO (R&S FPL1-B4) option generates a 10 MHz reference signal with a very
precise frequency. If installed, and if no external signal is used, this signal is used as
an internal reference. It can also be used to synchronize other connected devices via
the Ref. Out 10 MHz connector.
This option is not available for the R&S ZNLE
When the instrument is switched on, the OCXO requires an extended warm-up time
(see data sheet).
Remote command:
[SENSe:]ROSCillator:SOURce on page 602
7.2 Display settings
7.2.1 Display settings
Access: [Setup] > "Display"
Some general display settings are available regardless of the current application or
operating mode. For information on optimizing your display for measurement results,
see the application-specific result configuration descriptions.
● General display settings........................................................................................119
● Displayed items.....................................................................................................121
● Display theme and colors......................................................................................124
● External monitor settings.......................................................................................126
7.2.1.1 General display settings
Access: [Setup] > "Display" > "General"
This section includes general screen display behavior and date and time display.
Display settings
To Next Page
Loading...
Need help?
General
