R&S ZNL Series - Zoom Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
320User Manual 1178.5966.02 ─ 20
Decouple All Traces / Decouple Trc
Assigns independent scale settings to all traces / to the active trace.
Remote command:
n/a
10.3.3 Zoom tab
Provides graphical and stimulus zoom functions for cartesian diagrams.
The graphical zoom magnifies a (paraxial) rectangular portion of a diagram without
modifying any sweep parameters. The stimulus zoom also magnifies the selected rect-
angle, but at the same time narrows the sweep range of the active channel to the rec-
tangle's horizontal range.
Alternatives to Zooming
There are several alternatives to graphical/numerical zooming. Refer to the following
sections:
●
Chapter 4.3.2, "Zooming into the display", on page 58
●
Chapter 10.3.1, "Scale Values tab", on page 316
●
Chapter 4.4.4, "Touchscreen gestures", on page 79 (zoom stimulus via spreading
and pinching)
●
Chapter 10.2.1, "Stimulus tab", on page 311
Mode Graphical Zoom/Mode Stimulus Zoom
Switches between graphical and stimulus zoom mode.
Use the zoom selection button to initiate the selection of a (paraxial) rectangular zoom
area. Its label changes according to the selected zoom mode.
Scale softtool