R&S ZNL Series - Cal Devices Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
496User Manual 1178.5966.02 ─ 20
Unchecking "Auto Scale" prevents the traces from scaling as the measurement and/or
standard changes. Unchecking "Average On" turns off averaging.
"Format" selects the trace format for the limit check (see "Validation Limits"
on page 495).
Remote command:
CALCulate:CALValidate:AVERage[:STATe]
CALCulate:CALValidate:FORMat
Basic Mode
Switches to Basic mode
10.12.2 Cal Devices tab
Provides access to all functions for calibration kit management and cal unit characteri-
zation.
Background information
Refer to the following sections:
●
Chapter 9.5.2, "Calibration standards and calibration kits", on page 255
●
Chapter 9.5.5.3, "Characterization of calibration units", on page 265
The buttons in the "Cal Devices" tab open the following dialogs:
●
"Cal Connector Types...": See Chapter 10.12.2.1, "Cal Connector Types dialog",
on page 496
●
"Cal Kits...": See Chapter 10.12.2.2, "Calibration Kits dialog", on page 499
●
"Characterize Cal Unit...": See Chapter 10.12.2.3, "Characterize Cal Unit dialog",
on page 504
10.12.2.1 Cal Connector Types dialog
The "Cal Connector Types" dialog displays and modifies the list of available connector
types. Cal connector types must be selected in accordance with the connectors of the
measured DUT.
Access: [Cal] > "Cal Connector Types..."
Cal softtool