R&S ZNL Series User Manual

VNA GUI reference
R&S
®
ZNL/ZNLE
493User Manual 1178.5966.02 ─ 20
left = "Ref. Receiver" Pwr Cal Method
right = "Power Meter" Pwr Cal Method
Start Cal Sweep
Start the calibration sweeps for the selected port and power calibration settings and
close the dialog. The calibration is performed as described in "Calibration procedure"
on page 273.
Use the Power Cal Settings tab"Pwr Cal Settings" to modify the calibration procedure.
Remote command:
SOURce<Ch>:POWer:CORRection[:ACQuire]
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect[:ACQuire]
10.12.1.6 Cal Validation dock widget
The controls on the "Cal Validation" dock widget allow you to set up and run a Calibra-
tion validation in basic or advanced mode.
Basic mode
In basic mode, the validation runs automatically, with autodetected ports and the set-
tings specified in Advanced mode (default settings after a system [Preset]).
Cal softtool

R&S ZNL Series Specifications

General

Brand	R&S
Model	ZNL Series
Category	Measuring Instruments
Language	English