R&S ZNL Series - Page 646

Command reference
R&S
®
ZNL/ZNLE
646User Manual 1178.5966.02 ─ 20
CALCulate:CALValidate...
Commands related to Calibration validation.
CALCulate:CALValidate:AVERage[:STATe]....................................................................... 646
CALCulate:CALValidate:CHARacteriza.............................................................................646
CALCulate:CALValidate:FORMat..................................................................................... 646
CALCulate:CALValidate:RESPonse:IMAGinary:LOWer...................................................... 647
CALCulate:CALValidate:RESPonse:IMAGinary:UPPer.......................................................647
CALCulate:CALValidate:RESPonse:REAL:LOWer.............................................................647
CALCulate:CALValidate:RESPonse:REAL:UPPer..............................................................647
CALCulate:CALValidate:RESPonse:MAGNitude:LOWer.....................................................647
CALCulate:CALValidate:RESPonse:MAGNitude:UPPer..................................................... 647
CALCulate:CALValidate:RESPonse:PHASe:LOWer...........................................................647
CALCulate:CALValidate:RESPonse:PHASe:UPPer........................................................... 647
CALCulate:CALValidate:RESPonse:PRESet.....................................................................648
CALCulate:CALValidate:RUN.......................................................................................... 648
CALCulate:CALValidate:RUN:RESult?............................................................................. 648
CALCulate:CALValidate:STANdard.................................................................................. 648
CALCulate:CALValidate:AVERage[:STATe] <Boolean>
Disables/enables averaging for cal validation.
Parameters:
<Boolean> *RST: ON (1)
Manual operation: See "Preferences" on page 495
CALCulate:CALValidate:CHARacteriza <String>
Selects the CalU characterization to be used for the cal validation.
Use CALCulate:CALValidate:STANdard to select the CalU standard to be used
for the validation.
Parameters:
<String> *RST: 'Factory'
Manual operation: See "Characterization" on page 495
CALCulate:CALValidate:FORMat <Format>
Selects the trace format for the limit check
(CALCulate:CALValidate:RESPonse:...)
Parameters:
<Format> MLINear | REAL
MLINear
Magnitude and phase
REAL
Real and imaginary part
VNA command reference