R&S ZNL Series - Page 648

Command reference
R&S
®
ZNL/ZNLE
648User Manual 1178.5966.02 ─ 20
CALCulate:CALValidate:RESPonse:PRESet
Resets the cal validation limits
(CALCulate:CALValidate:RESPonse:REAL|IMAGinary|MAGNitude|PHASe:
LOWer|UPPer).
Usage: Event
Manual operation: See "Validation Limits" on page 495
CALCulate:CALValidate:RUN
Runs the cal validation with its configured settings.
Usage:
Event
Manual operation: See "Validate" on page 494
CALCulate:CALValidate:RUN:RESult?
Displays the result (PASS/FAIL) of the preceding cal validation (CALCulate:
CALValidate:RUN).
Usage:
Query only
Manual operation: See "Validate" on page 494
CALCulate:CALValidate:STANdard <Standard>
Selects the CalU standard to be used for cal validation.
Parameters:
<Standard> OPEN | SHORt | MATCh
CALCulate:DATA...
The CALCulate:DATA... commands provide access to the results of a measure-
ment.
Data format
The trace data is transferred in either ASCII or block data (REAL) format, depending
on the FORMat[:DATA] setting. If block data format is used, it is recommended to
select EOI as a receive terminator (SYSTem:COMMunicate:GPIB[:SELF]:
RTERminator EOI).
CALCulate<Chn>:DATA..................................................................................................649
CALCulate:DATA:ALL?................................................................................................... 652
CALCulate<Ch>:DATA:CALL...........................................................................................652
CALCulate<Ch>:DATA:CALL:CATalog?............................................................................653
CALCulate<Ch>:DATA:CHANnel:ALL?.............................................................................653
CALCulate<Ch>:DATA:CHANnel:DALL?.......................................................................... 654
VNA command reference