Command reference
R&S
®
ZNL/ZNLE
1016User Manual 1178.5966.02 ─ 20
<SecondCal> String parameter with the channel name (for <LocationSecond-
Cal>=CHANnel) or the calibration file name (for <LocationSe-
condCal>=POOL) of the first calibration.
<LocationSecondCal>CHANnel | POOL
Setting parameters:
<OutputCal> String parameter with the channel name (for <LocationOutput-
Cal>=CHANnel) or the calibration file name (for <LocationOut-
putCal>=POOL) of the resulting calibration.
Note: If (<OutputCal>,<LocationOutputCal>) matches one of the
input calibrations, this input calibration is replaced.
<LocationOutputCal> CHANnel | POOL
Return values:
<Joinable>
SYSTem:DATE
<Year>, <Month>, <Day>
The command queries or defines the instrument's current date setting.
Parameters:
<Year> Year, four-digit number
<Month> Month, two-digit number, 01 (for January) to 12 (for December)
<Day> Day, two-digit number, 01 to the number of days in the month
Example:
SYST:DATE?
Response: 2012,05,01 - it is the 1st of May, 2012.
SYSTem:DISPlay:CONDuctances <Boolean>
Changes the presentation of "capacitance C<i> in parallel with resistance R<i>" circuit
blocks in lumped de/embedding networks.
Parameters:
<Boolean> ON - display conductances
OFF - display capacitaces
Manual operation: See "Conductance in Embedding Networks" on page 142
SYSTem:FREQuency? <MinMax>
Queries the minimum and maximum frequency of the network analyzer. For an over-
view refer to the tables at the beginning of "[SENSe:]FREQuency..." on page 941.
Tip: In contrast to [SENSe<Ch>:]FREQuency:STARt? and the other sweep range
commands, SYSTem:FREQuency? can be used in all sweep modes.
Query parameters:
<MinMax> MINimum | MAXimum
VNA command reference
To Next Page
Loading...
