R&S ZNL Series - Page 570

Command reference
R&S
®
ZNL/ZNLE
570User Manual 1178.5966.02 ─ 20
Setting parameters:
<ChannelName> String containing the name of the channel setup you want to
delete.
A channel setup must exist to delete it.
Usage: Setting only
Manual operation: See "Closing a channel setup" on page 89
INSTrument:LIST?
This command queries all active channel setups. The query is useful to obtain the
names of the existing channel setups, which are required to replace or delete the chan-
nel setups.
Return values:
<ChannelType>,
<ChannelName>
For each channel setup, the command returns the channel setup
type and channel setup name (see tables below).
Tip: to change the channel setup name, use the INSTrument:
REName command.
Example:
INST:LIST?
Result for 3 channel setups:
'ADEM','Analog Demod','IQ','IQ
Analyzer','IQ','IQ Analyzer2'
Usage: Query only
Table 11-1: Available channel setup types and default channel setup names
Application <ChannelType> Parameter Default Channel Setup Name*)
Spectrum SANALYZER Spectrum
AM/FM/PM Modulation
Analysis
ADEM Analog Demod
I/Q Analyzer IQ IQ Analyzer
Noise Figure Measure-
ments
NOISE Noise
Vector Signal Analysis
(VSA)
DDEM VSA
Network analysis Vna VNA
Note: the default channel setup name is also listed in the table. If the specified name for a new channel
setup already exists, the default name, extended by a sequential number, is used for the new channel
setup.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel setup.
Setting parameters:
<ChannelName1> String containing the name of the channel setup you want to
rename.
Common instrument commands