R&S ZNL Series - Page 1033

Command reference
R&S
®
ZNL/ZNLE
1033User Manual 1178.5966.02 ─ 20
The marker must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe]
ON or CALCulate<Chn>:MARKer<Mk>:REFerence[:STATe] ON.
Note: These commands are the ZVR-compatible equivalents of CALCulate<Chn>:
MARKer<Mk>:FUNCtion:EXECute MINimum | MAXimum and CALCulate<Chn>:
MARKer<Mk>:REFerence:FUNCtion:EXECute MINimum | MAXimum.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number (ignored for reference markers)
Usage: Event
CALCulate<Chn>:MARKer<Mk>:SEARch:LEFT
CALCulate<Chn>:MARKer<Mk>:SEARch:NEXT
CALCulate<Chn>:MARKer<Mk>:SEARch:RIGHt
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch:LEFT
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch:NEXT
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch:RIGHt
These commands selects a search mode for the related marker (see "Marker address-
ing" on page 681), and initiate a search for the next valid peak to the left, the next high-
est or lowest value among the valid peaks, and the next valid peak to the right.
The marker must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe]
ON or CALCulate<Chn>:MARKer<Mk>:REFerence[:STATe] ON.
Note: These commands are the ZVR-compatible equivalents of CALCulate<Chn>:
MARKer<Mk>:FUNCtion:EXECute LPEak | NPEak | RPEak and
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:EXECute LPEak |
NPEak | RPEak.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number (ignored for reference markers)
Usage: Event
CALCulate<Chn>:MARKer<Mk>:SEARch[:IMMediate]
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch[:IMMediate]
Initiates a search for the related marker (see "Marker addressing" on page 681).
Before using this command:
●
The marker must be created using CALCulate<Chn>:MARKer<Mk>[:STATe]
ON or CALCulate<Chn>:MARKer<Mk>:REFerence[:STATe] ON.
●
The search function must be selected using CALCulate<Chn>:MARKer<Mk>:
FUNCtion[:SELect] or CALCulate<Chn>:MARKer<Mk>:REFerence:
FUNCtion[:SELect].
VNA command reference