VNA GUI reference
R&S
®
ZNL/ZNLE
347User Manual 1178.5966.02 ─ 20
Related information
Refer to Chapter 9.1.3, "Traces, channels and diagrams", on page 185.
In remote control, each channel can contain an active trace. The active remote traces
and the active manual trace are independent of each other; see Chapter 11.4.2.2,
"Active traces in remote control", on page 625.
10.6.1.1 Controls on the Traces tab
The "Trace Manager..." button opens the Trace Manager dialog.
Active Trace
Selects an arbitrary trace of the active channel setup as the active trace in its channel
and diagram. At the same time, it sets the trace's diagram and channel as the active
Diagram / Channel.
Tip: You can also select an item in a trace list or a trace line in a diagram to make the
related trace the active one.
This function is disabled if only one trace is defined.
Add Trace
Copies the active trace (within the active channel), assigns it to the same diagram, and
makes the new trace the active one.
"Copies" means that the new trace is created with the settings of the former active
trace, i.e. the former and the new active trace overlay each other. Change the refer-
ence position or select a different measurement for the new trace to separate them
(see Chapter 10.7, "Meas softtool", on page 394).
The new trace is named "Trc<n>", where <n> is the smallest positive integer such that
this name is not already used. The name can be changed in the Trace Manager dialog.
Trace softtool
To Next Page
Loading...
