R&S ZNL Series - Page 450

VNA GUI reference
R&S
®
ZNL/ZNLE
450User Manual 1178.5966.02 ─ 20
A first marker labeled "M1" is automatically created when the [Mkr] or [Mkr->] hardkey
is pressed. The "Mkr 1" ... "Mkr 10" and "Ref Mkr" softkeys enable the corresponding
markers.
"Add Marker" adds a new marker.
Related information
Refer to Chapter 9.2.1.3, "Markers", on page 197.
Mkr <i> Stimulus / Ref Mkr Stimulus
Gets/sets the stimulus value of the active marker.
Remote command:
CALCulate<Chn>:MARKer<Mk>:X
CALCulate<Chn>:MARKer<Mk>:REFerence:X
Mkr <i> Arb. Response / Ref Mkr Arb. Response
Gets/sets the response value (Y position) of an "Arbitrary" marker (see "Marker Mode"
on page 453).
Remote command:
CALCulate<Chn>:MARKer<Mk>:Y
CALCulate<Chn>:MARKer<Mk>:REFerence:Y
On
Enables/disables the active marker.
Markers remember their "Marker Props" while disabled (see Chapter 10.10.2, "Marker
Props tab", on page 452). The marker properties are definitely lost when the associ-
ated trace is deleted.
Marker Settings softtool