R&S ZNL Series - Page 636

Command reference
R&S
®
ZNL/ZNLE
636User Manual 1178.5966.02 ─ 20
Bit No. Meaning
5 Command error
This bit is set if a command which is undefined or syntactically incorrect is received. An
error message with a number between -100 and -200, which describes the error in greater
detail, is entered into the error queue.
7 Power On (supply voltage on)
This bit is set when the instrument is switched on.
Related common commands
The Event Status Register (ESR) can be queried using ESR?. The Event Status Enable
(ESE) register can be set using the command *ESE and read using *ESE?.
See also Common commands
STATus:OPERation
The STATus:OPERation register contains conditions which are part of the instrument's
normal operation. The analyzer does not use the STATus:OPERation register.
STATus:QUEStionable
The STATus:QUEStionable register indicates whether the acquired data is of ques-
tionable quality and monitors hardware failures of the analyzer. It can be queried using
the commands STATus:QUEStionable:CONDition? or
STATus:QUEStionable:EVENt?.
Bit No. Meaning
9 INTegrity register summary
This bit is set if a bit is set in the STATus:QUEStionable:INTegrity register and the associ-
ated ENABle bit is set to 1.
10 LIMit register summary
This bit is set if a bit is set in the STATus:QUEStionable:LIMit1 register and the associated
ENABle bit is set to 1.
STATus:QUEStionable:LIMit<1|2>
The STATus:QUEStionable:LIMit<1|2> registers indicate the result of the limit
check. They can be queried using the commands
STATus:QUEStionable:LIMit<1|2>:CONDition? or
STATus:QUEStionable:LIMit<1|2>[:EVENt]?
STATus:QUEStionable:LIMit1 is also the summary register of the lower level
STATus:QUEStionable:LIMit2 register.
The bits in the STATus:QUEStionable:LIMit1 register are defined as follows:
VNA remote control basics