R&S ZNL Series - Page 640

Command reference
R&S
®
ZNL/ZNLE
640User Manual 1178.5966.02 ─ 20
The ENABle parts of the status registers can be set such that arbitrary bits in an arbi-
trary status register initiate an SRQ. To use the possibilities of the service request
effectively, all bits in the enable registers SRE and ESE must be set to "1".
Example: Use *OPC to generate an SRQ
1. Set bit 0 in the ESE (Operation Complete).
2. Set bit 5 in the SRE (ESB).
3. Insert *OPC in the command sequence (e.g. at the end of a sweep).
When all commands preceding *OPC have been completed, the instrument generates
an SRQ.
Example: Generate an SRQ when a limit is exceeded
1. Set bit 3 in the SRE (summary bit of the STATus:QUEStionable register, set
after STATus:PRESet)
2. Set bit 10 in the STATus:QUEStionable:ENABle register (summary bit of the
STATus:QUEStionable:LIMit1 register)
3. Set bit 1 in the STATus:QUEStionable:LIMit1:ENABle register
The R&S ZNL/ZNLE generates an SRQ when the event associated with bit 1 of the
STATus:QUEStionable:LIMit1:ENABle register occurs, i.e. when any point on
the first trace fails the limit check.
Example: Find out which event caused an SRQ
The procedure to find out which event caused an SRQ is analogous the procedure to
generate an SRQ:
1. STB? (query the contents of the status byte in decimal form)
If bit 3 (QUEStionable summary bit) is set, then:
2. STAT:QUES:EVENT? (query STATus:QUEStionable register)
If bit 10 (QUEStionable:LIMit1 summary bit) is set, then:
3. Query STAT:QUES:LIMit1:EVENT? (query STATus:QUEStionable:LIMit1
register)
If bit 1 is set, then the first trace failed the limit check.
The SRQ is the only possibility for the instrument to become active on its own. Each
controller program should set the instrument such that a service request is initiated in
the case of malfunction. The program should react appropriately to the service request.
VNA remote control basics