Rockwell Automation PowerFlex 7000

Parameters Listed by Group 2-217
7000-TD002A-EN-P – September 2007
Parallel Drive Parameters
Name Min. Max. Default Units
Read-
Only
Access
716 Drive ID 0 7 0 N Advanced
717 Powerup Config - - Single Drive N Advanced
718 Master Mask - - 11111111 Hex N Advanced
719 Acting Master ID 0 8 0 N Advanced
745 Drives in System 1 4 1 N Advanced
765 Reduced Capacity - - Enable N Advanced
722 PD Flags - - 0000000000000000 Hex N Service
720 PD Fault Word - - - Hex Y Advanced
721 PD Warning Word - - - Hex Y Advanced
723 PD Status - - - Hex Y Service
724 Drive0 Status - - - Hex Y Advanced
725 Drive1 Status - - - Hex Y Advanced
726 Drive2 Status - - - Hex Y Advanced
727 Drive3 Status - - - Hex Y Advanced
728 Drive4 Status - - - Hex Y Advanced
729 Drive5 Status - - - Hex Y Advanced
730 Drive6 Status - - - Hex Y Advanced
731 Drive7 Status - - - Hex Y Advanced
732 Master Flux Ref 0 65535 - Y Service
733 Master Torq Ref 0 65535 - Y Service
734 Master Isd Cmd 0 65535 - Y Service
737 Master Capacity 0 65535 - Y Service
735 Master Command - - - Hex Y Service
736 Sp Slave ID 0 8 - Y Service
739 Sp Command - - - Hex Y Service
738 Sp Capacity 0 65535 - Y Service
740 PD Flux Ref 0 65535 - Y Service
741 PD Torq Ref 0 65535 - Y Service
742 PD Isd Cmd 0 65535 - Y Service
746 PD Capacity 0 32767 - Y Service
743 PD Command - - - Hex Y Service
Drv Application Parameters
Name Min. Max. Default Units
Read-
Only
Access
760 ESP Surface Volt 0 8000 - V Y Basic
750 ESP Cable Resis 0.000 65.535 0.000 ohms N Service
751 Drv Application - - ID Fan N Basic