Instrument Functions
R&S
®
FSVA/FSV
350Operating Manual 1176.7510.02 ─ 09
Rel Limit Start ← Sweep List dialog box ← Sweep List ← Spectrum Emission
Mask
Sets a relative limit value at the start frequency of the range [dBc].
This parameter is only available if the limit check is set accordingly (see "Limit Check
1-4" on page 349).
Remote command:
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:RELative:STARt
on page 801
Rel Limit Stop ← Sweep List dialog box ← Sweep List ← Spectrum Emission
Mask
Sets a relative limit value at the stop frequency of the range [dBc].
This parameter is only available if the limit check is set accordingly (see "Sweep List
dialog box" on page 347).
Remote command:
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:RELative:STOP
on page 802
Close Sweep List ← Sweep List ← Spectrum Emission Mask
Closes the "Sweep List" dialog box and updates the measurement results.
Insert before Range ← Sweep List ← Spectrum Emission Mask
Inserts a new range to the left of the currently focused range. The range numbers of
the currently focused range and all higher ranges are increased accordingly. The maxi-
mum number of ranges is 20.
For further details refer to "Ranges and Range Settings" on page 358.
Remote command:
ESP:RANG3:INS BEF, see [SENSe:]ESPectrum:RANGe<range>:INSert
on page 800
Insert after Range ← Sweep List ← Spectrum Emission Mask
Inserts a new range to the right of the currently focused range. The range numbers of
all higher ranges are increased accordingly. The maximum number of ranges is 20.
For further details refer to "Ranges and Range Settings" on page 358.
Remote command:
ESP:RANG1:INS AFT, see [SENSe:]ESPectrum:RANGe<range>:INSert
on page 800
Delete Range ← Sweep List ← Spectrum Emission Mask
Deletes the currently focused range, if possible. The range numbers are updated
accordingly. For further details refer to "Ranges and Range Settings" on page 358.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:DELete on page 797
Measurement Functions
To Next Page
Loading...
