Instrument Functions
R&S
®
FSVA/FSV
539Operating Manual 1176.7510.02 ─ 09
For details on the connectors and compatible power sensors refer to the Quick Start
Guide, chapter 1, "Front and Rear Panel".
For details on compatible power sensors refer to the data sheet.
Power Sensors can also be used to trigger a measurement at a specified power level,
e.g. from a signal generator.
Figure 3-46: Power sensor support – standard test setup
Using the power sensor with several applications
The power sensor cannot be used from the R&S FSVA/FSV firmware and the R&S
Power Viewer (virtual power meter for displaying results of the R&S NRP power sen-
sors) simultaneously. After using the Power Viewer, close the application, then unplug
and replug the sensor. Afterwards the power sensor can be used by the
R&S FSVA/FSV again.
Instrument Functions - Power Sensor (R&S
FSV-K9)
To Next Page
Loading...
