Remote Control
R&S
®
FSVA/FSV
746Operating Manual 1176.7510.02 ─ 09
Parameters:
<Size> LARGe | SMALl
LARGe
Channel and adjacent-channel power measurements: diagram
in full screen.
Spectrum Emission Mask and Spurious Emissions measure-
ments: diagram or list in full screen, depending on the value of
the suffix.
SMALl
split screen (diagram and list and table)
*RST: SMALl
Example:
DISP:SIZE LARG
Displays the measurement diagram in full screen size.
DISP:WIND1:SUBW2:SIZE LARG
Displays the result list in full screen size.
DISP:WIND2:SIZE LARG
Displays the marker table in full screen size.
Mode: all
DISPlay[:WINDow<n>][:SUBWindow<m>]:SELect
This command selects which window (screen) is active for applications with more than
one measurement window. For measurements with additional subwindows (e.g. SEM,
ACLR), the subwindow can also be selected.
Suffix:
<n>
.
1...4
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<m> 1...2
1: graphic
2: table
For applications that do not have subwindows, the suffix <m> is
irrelevant.
Parameters:
*RST: 1
Example:
DISP:WIND1:SEL
Sets the window 1 active.
DISP:WIND1:SUBW2:SEL
Sets the focus on the table of window 1.
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] <State>
This command switches on or off the display of the corresponding trace. The other
measurements are not aborted but continue running in the background.
Remote Control – Commands
To Next Page
Loading...
